Page 1 of 1
looking for the type iv conversion flange
Posted: Sat May 26, 2007 11:59 pm
by ajb164
armand,
please email me with the cost of the flange my motor is close to being installed.
if anyone sees armand please let me know how to contact him so i can finish this project. if anyone knows him and how i can contact him please email me at
ajb164@yahoo.com
i am in the usa. so if you can let me know what the time to contact him too. thanks to anyone that can help.
adam
Posted: Sun May 27, 2007 10:56 pm
by Pine
PM me your e-mail address, and I'll put you in touch with Armand
Posted: Mon May 28, 2007 9:28 am
by didi
Pine, his e-mail is in his post
Posted: Sat Jun 02, 2007 4:28 am
by ajb164
ok thanks to who emailed me. i did recieve an email back from armand. i returned an email to him and havent heard back in a few days. dont mean to be a pest but i need this conversion to finish my type 3. he mentioned that its difficult to wire money to s.a. if this is true please let me know anyother ways. armand if you take paypal i can do this asap. so if anyone sees him or is great friends with him please get word to him that i am will to pay or trade what ever. have him email me again
thanks again to all who can and have helped me.
adam
Posted: Tue Jun 19, 2007 7:53 pm
by ajb164
armand
check your email. i have the seals and need an address to ship to. thanks
adam
Posted: Tue Jun 19, 2007 7:56 pm
by IMPI
Will do
Po Box 220
Orkney
South Africa
2621
Re: looking for the type iv conversion flange
Posted: Sat Jun 14, 2008 6:31 am
by damo99
I am also after impi and one of the type 3 to 4 conversion parts
my contact email address is
damien09@bigpond.com
thanks damien
Re: looking for the type iv conversion flange
Posted: Sat Jun 14, 2008 7:57 am
by IMPI
Ja the US guys always going on about being ripped off. you should read on the Samba about the saga of the Steiner Rad Wheels
I sent ajb164 a set of adaptor Flanges and now he is manufacturing them in the US.
I dont want copy right or anything A simple thank you and acnowledgement would have been enough.
Armand
Re: looking for the type iv conversion flange
Posted: Sat Jun 14, 2008 8:25 am
by Pine
I vote for
ajb164 to be removed from the Forum immediately. He probably voted for George W. as well
Re: looking for the type iv conversion flange
Posted: Sat Jun 14, 2008 9:02 am
by ZeroAxe
IMPI, I see that you are online. Am would like to PM you my email address and ask if you can just email me a pic of this flange. It is the one that takes the air from the air vents to the motor, no? IIRC, on the first forum ages ago, I asked about this too, but am not 100% sure that I had a response(no hard feelings though
). Thanks.