Aircooled VW South Africa

no wont cut any holes mabi some screw ones for the rev counter, think i will place the other under the center air vent

Sorry its just i have spent the last 2 weeks patching holes that have been drilled in stupid places in the dash in my beetle

my second idea but have to drill to much holes


update of where I've finaly placed my gauges:





my seats at the moment:




This is the main reason for redoing my seats:

updates on my project

mec oil press


here the 2 gauges are working.


night lights


rear bumpers primered


oil press senders


fuel filter under the tank

thread stripped


temp sensor fitted


temp gauge working


new inside door panel

Road clearance


All gauges working
2500rpm at 80kph or 3000rpm at 90kph


some short trip photos:
2500rpm at 80kph and after a while the temp stabilze at 100 deg

cruising at 80 pta east bronkhost road

beautifull sun set

Nice to see your single cab is mobile again Louis

Nice to see your single cab is mobile again Louis

yes desided wany start using it again. Still need to renew the seats when funds allow it.

Looks like a fun bus to drive - must be nice to cruise in...

yes you relax when driving.or cruising

some update progress:

Fixed the licence light


Cargo bay Etch primered


Fixed the RG leak


Load bay etch primed


Any one know or have an idea how to seal/weatherproof between the outer bulkhead and the loading bay?

Nice progress Louis. Does it leak into the "treasure chest" area ? Are you referring to the area where the cab "meets" the (upper) load deck area ?

Yes
Jolas did you had the same problem?

Its visible from the inside:

some more prograss:

getting sprayed(partly)






new bended& home made window latch(took 30 min after bending)


unbended rims - need work


before& after rust removal

stone chipped:

wide bed been bend back& rust removed