Engine bay before (sorry about the lousy photo) Engine bay after. Vintage Speed 1½" exhaust The above work all carried out by our own resident ACVWSA engine guru Tony Z who has done a flippen amazing job I must say. Big ups to you Tony!!!

Below is a small list of some of the work done:
- Heads very slightly slightly ported, compression ratio bumped up and new valves fitted
- Single carb replaced with a set of dual Weber 36 IDFs
- CB Performance Magnaspark 2 ready to run kit (distributor, coil and wires)
- Degreed crankshaft pulley
- CB Performance fuel pump & filter
- Vented Jaycee fuel pump block off
- Some tinware replaced & powder coated black (more to be replaced later)
- Full stainless Vintage Speed bay window 1½" exhaust and j-pipes all ceramic coated except for the tailpipe section
- Empi airfilters (temporary fit until 3½" CB Performance ones arrive)
- Dual stage immobiliser fitted.
She pulls really nicely now. Just need to get her onto a dyno to fine tune but that can wait for after Bug Jam 2013.
Thanks Tony Z for all the hard work, Muderick for the carbs and Dave Rowley for some of the parts. You guys rock!